Difference between revisions of "Backpack"

Revision as of 22:31, 6 March 2013

backpack_diagram.jpg

Ingredients for the backpack body mixture:

1.Get a large bottle of lepage white glue.

2.Get large quantities of generic white paper towel.

3.Water.

4.Xerox printer paper box (8x11)

5.Plastic wrap

6.Two 2x4’s

Steps to make the backpack

1.Fold a piece of paper towel twice lengthwise and tear into three equal strips.

2.Place a large plastic sheet on top of the 2x4’s to prevent mess.

3.Cover Xerox box with plastic wrap and place on the 2x4’s.

4.Mix glue and water in a large container to a 1:1 ratio.

5.Pour mixture into small, clean, yellow trough (if it is still here.)

6.Dip paper towel strips in mixture and place on the box vertically (always in the same direction.)

7.Put on 1 layer then let dry for 1 day.

8.Repeat step 6 and 7 until desired thickness.

9.Remove the box from the interior.

Materials for the oxygen tanks rig:

1.Two 2L pop bottles

2.The caps

3.Thirsty people to drink the pop before use

4.Drill

5.Hot glue gun

6.Glue for the gun

7.Screws

8.Block of wood 11 3/8 by 3 7/16 by 1 7/8

Directions:

1.Clean the 2L pop bottles and let dry.

2.Center the two pop bottle lids on the block

(credit for this goes to Spencer)

3.Draw a circle around the centered pop bottle lids

4.Drill a hole in the circled area 1 ½ cm wide and 1 ½ cm deep.

5.Fill the hole with hot glue and center the cap inside the glue so the bottles can still be attached.

6.Put a screw through the center of the cap while the glue is still hot to keep it attached better.

7.Wait for it to cool.

8.The oxygen rig is now ready.

9.Make sure the bottles don’t get permanently attached to the caps, you won’t be able to change the oxygen anymore.

Sublimator materials:

1.Floppy disk drive

2.Screwdriver

3.4 nuts and bolts for each one you are attaching

Steps:

1.Take the metal panels off the floppy drive.

2.Place the sublimator where you want it and drill 4 holes in each of the corners through to the backpack.

3.Use the nuts and bolts to attach the metal panel to the backpack.

4.Repeat for each backpack.

Materials for the backpack:

1.Backpack that will be cut up

2.Strong scissors that can cut through fabric

3.Drill

Instructions:

1.Cut the entire bag part off of the backpack; keep the straps and the part holding them together.

2.Drill holes in the top of the backpack to match this.

[1]

3.Take apart the strap connection and insert as seen above.

4.Reattach the strap connection.

5.Congrats on your now wearable backpack. Good luck in space!

How to insert the air tank rig into the backpack

1.Take the air tank rig and insert it block down.

2.Congrats, you’re done.

[2]

finished air tank rig

[3]

Backpack with oxygen rig and backpack straps in it

[4]

Sublimator on the side

Note, the photos that are external links are too high of a resolution to be put on this page, so they are on there own pages.

The placeholder photo is going to be added soon, I just have to rediscover the file.

I will be updating this page as we make more for the backpacks. More detailed photos will be added to help.

~Jared Kelly