Cold Starting

Cold Starting is a term used to refer to the act of using the Fuel cell or Battery to heat up the Reactor so that it may be able to start reactions to produce energy. The steps to cold starting in the software are below.

Habitat

• 1. Turn on fuel cell injector
• 2. Open up secondary bus
• 3. Connect fuel cell to bus
• 4. Connect containment to bus
• 5. Charge containment to 2000As
• 6. Disconnect containment from bus
• 7. Connect reactor heater (TEMP)
• 8. Let the reactor heat up till the fuel cell temperature is 110 centigrade
• 9. Connect battery to bus (The battery will aid the fuel cell and let the fuel cell cool)
• 10. Repeat steps 8 and 9 till reactor temperature is 80 centigrade (Glowing)
• 11. Turn on reactor injectors
• 12. Disconnect fuel cell and battery
• 13. Turn off fuel cell injector

AYSE

• 1. Connect battery to bus
• 2. Connect reactor heater (TEMP) to bus
• 3. Heat reactor to 80 centigrade (Glowing)
• 4. Turn on reactor injectors
• 5. Turn off battery